Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2001 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

CSB question.. 700 1987

posted by  wolf_walker on  Fri Jul 4 17:40 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Aug 11 19:29 CST 2012
[RELATED]

I replaced my CSB and u-joints about 20K ago on the wagon. It's had the thumpy on take-off thing going since then. I put off bothering with it till now since the rear was sagging. Got the rear done pretty much, it sits level, and my thumpy is still there. Today I shimmed the CSB up a bit, and if anything it's worse. Tomorrow I'll see if it likes being shimmed down, but I somehow doubt it.
I have a couple of questions.

For one I think it was a scantech support, are they crappy enough to maybe be a problem?

Two, are there any kinda guards for dust on these? There is a rubber boot on the rear side where the two shafts slide together which is in good shape, but are there any other guards for dust or crud? I see a listing for a Febi support, which in theory is better quality, but nothing anywhere for dust boots or anything.

Thoughts?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New CSB question.. [700][1987]
posted by  wolf_walker  on Fri Jul 4 17:40 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.