Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2004 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Camshaft Question 444-544

posted by  volvo65 on  Fri Jan 30 09:52 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Aug 21 09:29 CST 2010
[RELATED]

When I had the block at the machine shop I had them remove the old cam as I was going to put in a new IPD VV-71. Unfortunately, now I have no idea how to install the new one. I pre-lubed all the bearings and slid it in the block. I'm thinkling there must be some sort of seals or gaskets or something that are part of the installation but I can't find any material on installing the camshaft. The motor manual is pretty vague. All I can find is a stainless steel looking oblong piece of flat steel that goes over the end of the shaft and bolts to the block. Is that all that holds it in? I can feel some sort of spring tension at the end of the shaft, is that normal?
--
'61 PV544 - '65 PV544 - '64 Lincoln Continental






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Camshaft Question [444-544]
posted by  volvo65  on Fri Jan 30 09:52 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.