Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Brake failure switch repair 200

posted by  thecbdb on  Thu Feb 12 03:56 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jun 22 12:17 CST 2010
[RELATED]

The brake failure switch on my '80 244 diesel is leaking. I have already taken the junction block apart and replaced all the o-rings, and it is still leaking through the switch just a bit. I am neither willing to spend over $200 for a replacement, nor remove that f-ing junction again. I don't even need a brake failure notification, as I am quite capable of realizing that my brakes aren't working properly.

Have any of you simply put a brass plug in its place, or something of the sort? This is what I'm looking to do, but haven't had much luck in finding something that is the same size and has the same very fine threading.

I would love to hear your suggestions, if y'all have any.

Charlie






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Brake failure switch repair [200]
posted by  thecbdb  on Thu Feb 12 03:56 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.