Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2007 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

ECT replacement - both engine temp sensors the same/compatible? 700

posted by  Forsyth on  Mon Aug 17 17:42 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed May 26 20:59 CST 2010
[RELATED]

I think I might have made a mistake... I am trying to replace the ECT, which I thought was the one right above the knock sensor and under the intake manifold. It took forever to get it off, it does look about the same.

I was reading over the FAQS again to see if they had any tips on installing it because I can't get any type of 3/4 socket/wrench/etc.... to be able to turn after I fit it on it from the side....

Ok, I didn't not realize there are 2 different engine temperature sensors. Does anyone know if the one for the ECT is the same as the front one for the temp. gauge in car? I don't see any others online from say FCPGroton.

Thanks, some that terminology is throwing me - I'm fairly new to the whole process. Success at everything so far, but this has been the worst headache ever (trying to re-install it, then finding I'm doing the wrong one).





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ECT replacement - both engine temp sensors the same/compatible? [700]
posted by  Forsyth  on Mon Aug 17 17:42 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.