Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2004 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

S60 seats into a 122 120-130

posted by  Kabukie on  Sun Feb 28 18:44 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Dec 29 21:26 CST 2011
[RELATED]

Yes folks my S60 seat install is practically done. Tons of thanks to Klaus for his wiring diagrams.

Used 1.25in square tubing to raise the seats off the floor. Used the two rear holes from the original seats to mount the new railing.
The only modification needed was to the drivers side seat. I relocated (I have no clue what it is???) a round metal unit with two wires going into it and tucked it under the seat leather for the seat back. I then cut the mounting point for said unit off. The picture attached shows the parking break clearance and what is left of the cut off bracket.

Still trying to get the passenger seat working under power. Will also put a separate fuse box somewhere under the dash.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 S60 seats into a 122 [120-130]
posted by  Kabukie  on Sun Feb 28 18:44 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.