Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2011 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Solderless Wiring, fuel pump sending unit 700 1988

posted by  TreKronor on  Tue Apr 13 13:10 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Apr 13 13:37 CST 2010
[RELATED]

Hey guys, good evening...

I had to wire up a fuel pump in tank sending unit today. The soldering iron I have is junk and I need to get this thing in the car. I stripped about a half inch off the end of all the wires I was connecting, then I basically did a braid twist type thing with the bare wires and slid up a piece of shrink tubing I had previously put on the wire, put heat to it and there. The wire balls were neat and tight, very secure. Is there any negative consequence to not using solder and having the connecting basically a wire knot? Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Solderless Wiring, fuel pump sending unit [700][1988]
posted by  TreKronor  on Tue Apr 13 13:10 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.