Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2004 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to check the brake light switch 900 1995

posted by  cips on  Mon Aug 2 17:11 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Aug 2 17:11 CST 2010
[RELATED]

Question(s) for the Brick Wizards.


How can you check the operation of the brake light switch without removing it (ie, what are the 4 wires for - 2 each brown-yellow, 1 green-yellow and 1 white-brown). Which wires to put the meter on?
Photobucket

I'm guessing 2 go to the bulb failure relay and 2 go to the shiftlock. Anyone have a schematic?

You see I have the no brake light problem (again). I had it 5 years ago and replaced the round red relay with a KAE one. These are a lot smaller than the originals. Anyway, I have a good signal between pins 54 and 54L/54R so I'm thinking the jumper bars and solder joints on it are all good. I just cannot get the extra voltage to the fresh 1157's to light up the second filament.

Could the relay still be bad with a good signal out to 54L/R?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to check the brake light switch [900][1995]
posted by  cips  on Mon Aug 2 17:11 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.