Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Can anyone help me with a simple machinists question re flare fittings? 200

posted by  twoOldVolvos on  Tue Sep 14 13:26 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon May 20 06:33 CST 2013
[RELATED]


Brickboard,

First, I am no machinist, but I do have a set of micrometers.

Recently, I replaced the steel lines on the steering rack of my 1990 240. I had a heck of a time getting my flare wrenches to fit. In fact I never was successful. The lines I bought were directly from Volvo.

So tonight I did a bit of measuring.

I measured the new flare nut at .444 inches.

My 12 mm flare wrench was too lose. But it should be because 12 mm = 0.472441 inches.

So I tried my 7/16 in flare wrench. It was too tight. But it should be because 7/16 = 0.4375 inches.

I blamed my Craftsman tools but now that I have done some measuring, maybe I spoke too soon.

So, can anyone tell me what size wrench I would have needed to fit that darned flare nut? Am I crazy?

Please advise. Thanks.

TwoOldVolvos.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Can anyone help me with a simple machinists question re flare fittings? [200]
posted by  twoOldVolvos  on Tue Sep 14 13:26 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.