Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2007 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

40 DCOE - MISAB MANIFOLD 120-130

Hello VOLVO people, I have A B18B and am installing a pair of 40 DCOE'S with a
MISAB manifold. The problem is that I have to pull the rings out of the head in order to fit the manifold flush with the head, as the manifold is not machined to accept the rings.
If I leave the rings out than there is a gap, which I assume will disrupt air flow. I am thinking about securing the rings in an old block and carefully grinding them down flush with the head. this would leave me with rings to fill the gap. any thoughts?? mayby the manifold is incorrect? MISAB 583003
THANKS






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 40 DCOE - MISAB MANIFOLD [120-130]
posted by  wilburwright subscriber  on Sat Jan 1 20:42 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.