Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2017 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

544 rear axel 444-544 1964

posted by  geneinforestlake on  Mon Feb 21 16:47 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Feb 20 21:31 CST 2014
[RELATED]

Had a 544 trailered home to Minnesota from sunny CA. Rear axel bearings grease dried out - need to replace outer bearings and seals, and while I'm at it the inners as well. Pinion seal is leaking - need to replace. Axel is a Spicer/Dana 4.1/1. So far I've got the brake back plate assembly off (driver side) and have gotten the pinion mate gear shaft and gears out of the differential. Don't see any c-clips.
Here's the question: I assume the axel is held in by the brake back plate. Is this correct? What's the next step to remove axel? Special puller?
Gene J. in Forest Lake






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 544 rear axel [444-544][1964]
posted by  geneinforestlake  on Mon Feb 21 16:47 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.