Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2003 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Carbed B20E Timing 140-160

New brake and fuel lines, new calipers, D-jet out, HIF6s on.

Valve lash adjusted to .018 when the engine was icy cold - radiator was out and that made it easier to get at the crank pulley bolt, which is a real pain with a double pulley and the viscous slip fan. Now I'll have to go back and do it again with a warm engine and the interfering stuff in front of it. What was I thinking! ;-(

OK, so much for history. Now the question:

I'm using the same vacuum retard (disconnected and plugged) distributor that was on there with the D-jet, and at the moment I'm getting 1000 rpm at 10° BTDC, going up to 1500+ when I advance to 20° BTDC.

What would be the most sensible initial timing with this set-up; 20° BTDC at 1500 rpm like the B20B, 10° BTDC at 600-800 rpm, like the B20E, if I can get the idle that low and steady (I have to fiddle with the carbs some more.), or reconnect the vac retard, and go for 20° BTDC at around 800 rpm and run the thing that way, backing off a few degrees if she pings too much going up-hill?

--
‘62 PV544 (B20, M41), '71 142E (Ex-automatic, now carbed), '93 240 Classic Wagon.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Carbed B20E Timing [140-160]
posted by  Sil subscriber  on Mon Mar 28 13:41 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.