Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2013 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

drive shaft length 120-130

posted by  rkent47 on  Wed May 4 07:57 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jun 2 09:45 CST 2014
[RELATED]

O.K. so I am working on a 1968 220 and have replaced the M40 with an M41 transmission. I was told that using the front section of an 1800 drive shaft would give me the correct length for the drive shaft. Well, no, that is not correct, or at least the front half of a drive shaft from a 1970 1800 does not work. My question - if I measure from the transmission flange to the rear end flange, that should be the measurement that a drive shaft shop needs - right! I had really hoped that the 1800 drive shaft would be the solution since I am leaving on a mission next Tuesday for a month. I had REALLY wanted to drive the Amazon to the Midsomer, but with the drive shaft issue won't be able to have it done in time either before I leave or after I get back... DRAT!!

Thanks

Kent

Too much iron, too little time






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New drive shaft length [120-130]
posted by  rkent47 subscriber  on Wed May 4 07:57 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.