Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2005 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replace Front Bearing/Hub Cause It's Squealing 900 1993

posted by  Milanomike on  Fri May 27 08:15 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 11 22:27 CST 2014
[RELATED]

OK, got a front bearing/hub that has been squealing off and on with my 945. Fortunately, figured it out before it seized, wheel rotates easily by hand.

Bought the new hub, cap and nut. Reading on how to do the job, the FAQ and manual say to slide hub on to axle making sure outer bearing inner ring stays in position. No problem, but then you are told that you must have 23 MM minimum from hub face to inner ring. I assume that having greater than the 23 is OK, correct? What is critical about this dimension or why is 22 and 3/4 MM no good? Just want to understand it better so I don't waste my 100+ bucks by doing the job again in a month. Thanks. Mike






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replace Front Bearing/Hub Cause It's Squealing [900][1993]
posted by  Milanomike  on Fri May 27 08:15 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.