Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2003 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Intake / Exhaust Manifold installation procedure B18D 120-130

posted by  Amazon66 on  Wed Mar 14 04:30 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 23 12:27 CST 2014
[RELATED]

Ready to reinstall manifolds on B18D. What is proper procedure?

Surfaces clean and flat, new gasket. Stud threads chased and lubed.

Do you use glue or light grease to position gasket? Then hang exhaust with thick washers and lock nuts, with front and rear getting thick washer with SU return spring mount while rear also gets heater pipe clamp over thick washer, followed by Intake with thin washers and lock nuts, then exhaust flange gasket to downpipe with 2 new lock nuts? All locknuts the same? On Model As we always installed brass locknuts on the down pipe mating flange for easier later removal.

What is proper torque value and pattern on B18D?

Thanks again,





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Intake / Exhaust Manifold installation procedure B18D [120-130]
posted by  Amazon66  on Wed Mar 14 04:30 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.