1992 945T Passenger window will power to the down position but not up. Naturally this happens two days before the hurricane is scheduled to arrive.


I have removed the switch and it checks OK per the Mike Ponte switch schematics. Probably don't have time to trace the down power wire in the door or after it disappears into the body for a break.

Here is my question: With the switch removed can I put +/-12 VDC on two of the wires at the door connector and just power the window up for now? If so which two?

I think that to run the window up the switch connects its terminal 4 (red/yellow wire) to terminal 1 (blue wire) and terminal 5 (red/grey wire) to terminal 2 (red wire). So if I put +12 VDC on 1 (blue) and its - on 2 (red) then I think it will run the window up right?

Will probably wait for daylight to try this.

Brian Mee
92 945T