Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

HIGH BEAMS inoperable; turn signal switch problem/s 1993 240 200

posted by  AlaskanPrincess on  Tue May 7 15:43 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jan 7 15:38 CST 2014
[RELATED]

New adoption: 1993 240 wagon!
First - turn signal switch, according to owner's manual, should have 2 positions (for each direction/turn) - "the driver can flash the turn signals by moving the turn signal lever to the first stop and holding it there."
I do NOT have two 'stops' only one - either turn signals are on, or off. (It does seem like the timing is a bit off when they turn off....)
HIGH BEAMS - when I pull (turn signal) lever back (toward steering wheel, me) as long as I am holding it in place I have high beams. There is no 'click' to turn high beams on (and then no 'click' to turn them off).
Suggestions?
This vehicle is NOT equipped with cruise control. IF it turns out that I need to replace the turn signal switch would it be an issue to put in a switch WITH cruise controls included - thinking to future where I might add cruise control (IF I can find components at a reasonable price!) or - just deal with appropriate switch when and if that time ever comes?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New HIGH BEAMS inoperable; turn signal switch problem/s 1993 240 [200]
posted by  AlaskanPrincess  on Tue May 7 15:43 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.