Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Anyone pressed in front control arm bushings? 200 1993

posted by  woodshavings on  Sun Sep 25 17:43 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 08:22 CST 2014
[RELATED]

I'm getting ready to replace the front control arm bushings with some Volvo OE bushings. I have access to a 12 ton press, and have been searching for the right size cups and drifts to do the job.

I'm looking for suggestions and tips/tricks for doing this safely and efficiently. I only get to take the car out of commission for the weekend, so I want to have all the tools and techniques ready to go.

I've read the green book and Bentley manual, which are basically the same thing.

Are there any particular pipe and/or socket sizes for pressing the bushings off and on? Any setup advice?

Should I borrow a kit from an auto parts store?

What have you found successful?

Thanks.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Anyone pressed in front control arm bushings? [200][1993]
posted by  woodshavings  on Sun Sep 25 17:43 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.