Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Tools required for front end rebuild 200 84

posted by  someone claiming to be David Wein on  Thu Feb 15 05:46 CST 2001 [RELATED]

Hi folks. I am about to take on a rebuild of the front end on my 84 242T. I will be replacing:

struts (Bilsteins, and yes, I am getting the inserts)

ball joints

outter tie rod ends

control arm bushings

I am curious as to what "special" tools I will really need. I know I need to either buy or rent a good spring compressor. Other than that, will I need a press for the ball joints and rod ends, or will a pickle fork work? I will be replacing all four, so I don't really care about tearing the old boots. If using a pickle fork, should I seperate the ball joint from the lower mount while still on the car?

In terms of extracting the strut insert, will I need any special tools or can I make it work (correctly) with some big metric sockets and wrenches? I will be taking the control arms to a shop to be pressed.

Thanks,

Dave





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tools required for front end rebuild [200][84]
posted by  someone claiming to be David Wein  on Thu Feb 15 05:46 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.