Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

K-Jet/Thermal Time Switch/Which Wire? 200 80

posted by  someone claiming to be Brian in CA on  Sun Nov 11 09:38 CST 2001 [RELATED]

Troubleshooting a really hard-starting cold 240 and found that there is nothing connected to the Thermal Time Switch (disconcerting at best). The harness was haphazardly repaired here and there by PO and I have found two wires that *may* be the ones I need to connect, but there is no Bosch connector at the end to verify -- just bare, taped wire.

Found a blue/yellow and white wire together that are loose, hanging down near the front of the starter solenoid that are the right length. According to both Haynes and the following archive, these are the right wires:

http://www.brickboard.com/ARCHIVES/1998FEB/10087.shtml

Somebody please tell me these are the right wires AND maybe tell me which one goes to which post on the thermal time switch or does it even matter? Thanks an abundance.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New K-Jet/Thermal Time Switch/Which Wire? [200][80]
posted by  someone claiming to be Brian in CA  on Sun Nov 11 09:38 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.