Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

sleeve clearances in PRV engine 700 84

posted by  someone claiming to be James Duggan on  Mon Jul 5 18:53 CST 1999 [RELATED]

I will replace the head gaskets and my Haynes manual specifies ever so slight clearances for the cylinder sleeves above the aluminum block.

Q/ How important is it for the clearances to be correct?

Two sleeves in my engine are flush with the block and the other sleeves have the slight clearances. I would prefer to avoid removing the sleeves pistons. I am planning to drive this car with new gaskets, cams and some new rockers and valves, for three to five years.

James

Calgary, Canada





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New sleeve clearances in PRV engine [700][84]
posted by  someone claiming to be James Duggan  on Mon Jul 5 18:53 CST 1999 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.