Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2009 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

distributor nightmare 700 88

This may be a repost of the same information, but I don't see it on the board. Here goes again.

My 99-740 is showing the classic symptoms of a defective Hall Sensor. So, I went out to replace it. The third strike of the hammer showed the error of my ways. $70.00 poorer and I took it to the local Volvo dealer to install. Guess what, they did it for free.....whow!

Problem is I have forgotten the order of wires into the connector. The hall effect sensor has a black, green and red wire that has to terminate in a connector that Volvo describes as the "housing" in positions listed as "+", "0" and "-". Which goes where?

Any help would be greatly appreciated.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New distributor nightmare [700][88]
posted by  someone claiming to be ron eames  on Tue Aug 21 05:35 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.