Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2001 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Can you remove the seal holder when intermediate seal in too far? 700 1992

posted by  someone claiming to be Guy W on  Fri Nov 30 14:00 CST 2001 [RELATED]

Got a big problem! I am trying to replace the front seals on our 745 non turbo engine. I got the cam and crank out no problem But the intermediate seal was set further in, and when I went to try to pry (using small screwdriver)it out I just pushed it in further. Now it is in all the way and I dont see any way to remove it without scratching the metal surfaces, which I dont want to do. Can I remove the cover that holds the crank and intermediate seals to get it out? I know it will be more trouble but I seem to have no other choice. Do I need to drain the oil before doing this? Will it affect any moving parts? What is the torque specs for the bolts when reinstall? The Haynes manual does not say anything about this cover- I think they used an older model engine.

Thanks





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Can you remove the seal holder when intermediate seal in too far? [700][1992]
posted by  someone claiming to be Guy W  on Fri Nov 30 14:00 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.