Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2013 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

clutch cable adjusted all the way 'in' after replacing clutch 200 1987

posted by  thaywood on  Sun Dec 30 01:59 CST 2001
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jun 29 08:38 CST 2014
[RELATED]


I just replaced the clutch in my 1987 240 and had to adjust the clutch cable as far "in" as it would go, that is, tightening (raise pedal). The clutch seems to work fine, but I figure something is not quite right here. It is the original cable.

Possible clue: When I had the transmission out I noticed the release arm doesn't pull back all the way. It sits about in the middle of it's range of motion. I don't know if that's the way it's supposed to be or not. The release arm doesn't look like it is bent but I could be wrong, or it could have nothing to do with the release arm.

BTW, I've been planning this clutch job since last spring, thanks to everyone who helped with my occasional questions.

Terry






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New clutch cable adjusted all the way 'in' after replacing clutch [200][1987]
posted by  thaywood  on Sun Dec 30 01:59 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.