Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2005

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

M46 tranny

posted by  twofourfour on  Fri Jan 25 13:06 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hi Everyone,

I'm working on tearing down an M46 and a B21ft at the moment. I'm a ways into each, and the engine is going smooth right now. The M46 has stagnated because of that stupid lockring mounted on the shaft that runs the gears. I'm talking about the smaller one. I bought a snap ring tool from Shucks which the locking quickly broke (stripped the threads) and I've been trying to use needle nose pliers and a combo of 2 wrenches prying against one enough to get the ring open enough to jab a screwdriver in there and pry it out...its starting to piss me off and if I didn't think I would have a hard time finding another one I would just cut it off with a dremel tool...but I think I would have a hard time finding this thing...soooo anyone have any tricks getting this lockring off?

Thanks,
Will







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M46 tranny
posted by  twofourfour  on Fri Jan 25 13:06 CST 2002 >
  • New M46 tranny
    posted by  daves1800  on Fri Jan 25 13:18 CST 2002 >
    • New tool
      posted by  twofourfour  on Sat Jan 26 15:15 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.