Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Hall sensor shorting out on 87, 740 GLE 700

I have gone through 2 distributors in a short time. I replaced the plug on the first one. The hall sensor has blown on both of them. When the car is running it misses slightly, and would occassionally die, but mostly run, idle, warm up just fine. I had a new Voltage Regulator installed in December. Could this be the culprit? Is the Hall sensor somehow getting a burst that shorts it out? Is it possible to install an inline fuse that would blow first? Should I trace the wires for the plug back to the Computer in search of a short? I hope someone will have input other than "better replace the whole wiring harness".
Thanks
N.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hall sensor shorting out on 87, 740 GLE [700]
posted by  vlvo  on Fri Mar 1 10:40 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.