Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Anybody ever used cotter pins on Girling brakes? 200

posted by  someone claiming to be DeWayne on  Wed Mar 6 04:42 CST 2002 [RELATED]

I bought new caliper hardware kits for the front Girling calipers.
The little clip that holds the long pins in the caliper will hit against the dust boots. I'm wondering if anyone has tried to use cotter pins to avoid contact with the dust boots. I'm not sure the hole in the pin would be large enough for a cotter pin to fit into it. Any tricks to keeping the clip from contacting the dust boots, or should I not be concerned about that?

Thanks...!

DeWayne






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Anybody ever used cotter pins on Girling brakes? [200]
posted by  someone claiming to be DeWayne  on Wed Mar 6 04:42 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.