Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine Inlet Work 200 1984

posted by  sandkv on  Sun Mar 10 17:09 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Brickboarders,
I have decided to do some work on my inlet side on my 240GL 1986 wagon. I have 186000KMS (Australian car) I have the usual problems:
Degrading wiring harness to injectors rotten insulation, decided to replace the insulation tape with new wire sections.
Unknown state of flame trap and hoses, should give it a clean (don't know if it has ever been done)
Engine runs a little rough at idle, often have to crank hard to warm start, sometimes hesitant when cold start.
Possible dirty injectors, never been touched?? will buy new seals and take them somewhere to be cleaned.
Any other suggestions for work to be done at this time? I will probably pull the manifold to make life easier (flametrap acess), do I need new manifold gasket?
Thanks for any suggestions
Karl

86 240,01 V40






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine Inlet Work [200][1984]
posted by  sandkv  on Sun Mar 10 17:09 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.