Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Engine code 413 on port 6 & code 121 on port 2 200 1991

posted by  hobbit on  Fri Mar 15 02:10 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hello all,
It has been a while since my last post. I had code 121 on port 2 show up a few times this winter. The contacts on the wiring harness to the Air flow metering device is corroded as well as the contacts on the device itself. I cleaned them with contact cleaner and that works for a couple of months. Perfromance does not appear to change when the check engine light comes on, so I assume it is a momentary contact failure. Any suggestions for a long term solution to contact corrosion?
What is new is this code 413 on the other place you can plug in the diagnostic wire; port 6. Does anyone know what the other port is for and what the code means?

Thanks in advance,
Steven Manseau
Billerica, MA






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine code 413 on port 6 & code 121 on port 2 [200][1991]
posted by  hobbit  on Fri Mar 15 02:10 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.