Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2006 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

dawes device problems, help needed 700

The boost guage I installed by tapping into the vaccum line leading to my stock boost gauge only reads about 5 psi max. I have a dawes device which I installed and the boost stayed the same as it was supposed to. Once I started to adjust the dawes device I haven't noticed much raise in my boost level yet and my car dies after hard acceleration( the rpm's go from around 2500 straight down to close to 0). Shouls I have more stock boost pressure than this in my 1990 760? and what can I do to stop the car from dying after hard acceleration of what is causing the dying.

Thanks in advance, any and all input is greatly appreciated, I hope to get up and running higher boost soon,

Duff






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New dawes device problems, help needed [700]
posted by  duffman  on Sun May 12 10:32 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.