Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2022 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

idles really rough then stalls, after cleaning throttle body, help 700 1990

posted by  yorkbrick on  Mon Aug 26 19:27 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hey bricksters!
Need some help. I thought today I would do some PM work on my 90 740ti brick.
I flushed the throttle body with carb and choke cleaner. I was quite liberal with the spray. I did not remove the body but, I did excersise the butterfly a couple of times. I did remove Idle valve to inspect and it seemed OK? It was slightly opened. I tested for resistance and it was 8 ohms and thats ok. Then I checked for any codes and their was none. Did reset anyways.

The engine when started runs like at 1500rpm for a few minutes then goes to 800ish. But when I rev the engine a few times it drops below regular idle and then stalls. Runs great when just driving along.
Thanks for any help.
It ran fine before I attempted this work.
Yorkbrick
--
90 744ti, K&N, IPD lowering springs, M46, 110k, 35%tint,






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New idles really rough then stalls, after cleaning throttle body, help [700][1990]
posted by  yorkbrick  on Mon Aug 26 19:27 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.