Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2000 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Hi or Low 700

I had one of those all plastic heater hose valves break off last week at a very bad place on the highway. Replaced it but noticed ? heat was not as hot as could be. I started to look at the heater hose attachments into the firewall. The 745 1990 turbo that broke plus two others one at 745 turbo 1988, and 740 1989 GLE all have the heater hoses connected as this: Top goes to the metal return pipe into the water pump and the bottom from the side of the head (HOT) into the valve and then into the bottom connector on the firewall.

The 700 manuals I have have no diagrams of this. The 700/900 FAQ says the hoses should be the reverse of the three 700 Volvos we own.

OK What is the correct placement of the heater hoses ? Thank You Very Much.
Mr. turbodog # 3

PS. I think two of the Volvos have never touched in the heater hose areas. These to my knowledge are factory installed.


six Volvos






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hi or Low [700]
posted by  turbodog #3  on Mon Nov 18 06:21 CST 2002 >
  • New Hi or Low
    posted by  UncommonDenominator  on Mon Nov 18 06:54 CST 2002 >
    • New Hi or Low
      posted by  turbodog #3  on Mon Nov 18 15:02 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.