Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Spark plug wire to plug connection question... 200

posted by  Strackerjack on  Thu Nov 21 01:07 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 8 19:11 CST 2014
[RELATED]

I've been messing with my spark plug wires (one cylinder not firing) and in the process I realized these aren't like the ones on my old Chevy's!

inside the boot that goes on the plug there is only a small hole with a clip that looks like it clips onto the small diameter threaded metal end of the spark plug.

my issue is that it would seem that when I place the boot over the spark plug I don't feel like the clip is coming into contact with the plug let alone clipping onto it!

have I threaded my plugs too far into the engine? thus making it so the metal plug wire boots won't allow the clips to reach the plug?

OR is it supposed to be like this with the spark jumping from the clipped hole to the spark plug?

tia

jack

'86 245, 244,000 mi.

p.s. - it's running fine but I had a bad wire and I'm wondering if the lack of connection might be cause my new wires to go bad.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Spark plug wire to plug connection question... [200]
posted by  Strackerjack subscriber  on Thu Nov 21 01:07 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.