Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2007 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

OilSeals - Filter - Startup - Flametrap - Question 700

posted by  someone claiming to be muchostupido on  Wed Dec 4 16:18 CST 2002 [RELATED]

86 740 GLE
My front oilseal was blown out the second time in 4 years.

The PCV / Flametrap and hoses are clean and not clogged.
Question 1: For what is the brass flametrap anyway?


I had an oilchange about 2 weeks ago.
Question 2: Could it be, that at the startup after the oilchange
with a new! filter there is a peak in crankcase pressure
which leds to the blown seals?


Most probably there was a backfire during startup a cold
engine one early morning. Though I didn't notice any mishaps.
Question 3: In order to prevent backfires, would it help
to release the starter/ignition key maybe a half second later,
just to make sure the engine is running instead of 'burping'.


Besides these 3 points I'm clueless what makes the seals move?

TIA





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New OilSeals - Filter - Startup - Flametrap - Question [700]
posted by  someone claiming to be muchostupido  on Wed Dec 4 16:18 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.