Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Water Pump and Metal Heater Pipe 200 1985

posted by  stxavier2003 on  Fri Dec 6 12:49 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jun 17 14:01 CST 2007
[RELATED]

Well, I noticed the temperature of the heat and the temperature gauge on my 1985 240 being rather cool. I figured maybe the thermostat was stuck open and that was making it run cold in this cold weather. Then today I noticed the oil light dim out rather than go out right after I start it. Not good, I know. Well I go home today and smelled burning ethylene Glycol and looked under the hood. It appears that the Metal pipe that fits into the back of the water pump is squirting to some degree coolant on my oil pressure sender and the alternator. I know there is an O ring there but is there anything I can do here other than new water pump. Do you guys think some blue RTV around the joint there would hold for at least a while? Thanks all.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Water Pump and Metal Heater Pipe [200][1985]
posted by  stxavier2003  on Fri Dec 6 12:49 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.