Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re-using bolts for ball joint to strut connection?/tie-rod removal tool? 200

posted by  chapster on  Fri Jan 10 01:21 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Mar 6 16:30 CST 2011
[RELATED]

Greetings
I'm getting ready to replace the ball joints and front end bushings on my 86 and 90 240s.
The Bentley manual says to never re-use the self-locking bolts on some of these components. I know that the ball joints usually come with the 3 new control arm bolts, but is it okay to reuse these other bolts, to struts/ control arm to body bolts, if I just use a little lock-tite when putting in the new joints and bushings am I G2G?
Are these bolts stressed upon removal or is this just a Volvo recommendation?

Also what is recommended to remove the outer tie-rod end from wheel assembly,
puller/ press, any specific size to buy?


Over and out
Chapster






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Re-using bolts for ball joint to strut connection?/tie-rod removal tool? [200]
posted by  chapster  on Fri Jan 10 01:21 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.