Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2005 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Bolts stuck again - good ideas needed!! 700

posted by  gholmer on  Sat Jan 18 05:16 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Removing the turbo and the exhaust manifold. I have two bolts left, the one for the stiffener bracket for the exhaust manifold and one on the oil pipe underneath the turbo. The Haynes manual says to remove that pipe on the block but there is no bolt there, it just goes into the block. I can't just pull it out can I? I can't access the bolt from underneath the car as there is a crossmember in the way.

The stiffener plate one is even worse, I cannot even reach that one and again, no access from underneath as the oil filter is in the way and removing that won't make any difference because the bit the oil pipes from the oil cooler is attached to will still be in the way.

Any ideas, anyone?

George
--
1987 745 GLE Turbodiesel Intercooler (D24TIC/M46) 190k and 1988 745 Turbo Intercooler (B230FT/M46) 290k






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bolts stuck again - good ideas needed!! [700]
posted by  gholmer  on Sat Jan 18 05:16 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.