Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How tight should vacume lines hold onto connectors? 200 1993

posted by  someone claiming to be BrickOCheese on  Thu Feb 20 13:01 CST 2003 [RELATED]

So I can't spell vaccume!

:) How tight should they be? The larger ones with clamps obviously should not budge. But how tight should the smaller ones be? Should one have to twist and pull or is it ok if they just slide/pop off rather easily? e.g the one that goes to the firewall just slides off effortlessly on mine. Too loose?

Just wondering if they are getting old and air is slipping into loose connections.

If too loose, how can you "tighten"/seal them up?

Thanks.

--

Pete
1993/244/152k

I wish someone published an extensive list/FAQ of what parts should look like or feel like or sound like. Having only owned the car in its 10th year makes it hard to know what's not acting quite right. Then again, I also wish I wasn't a perfectionist and could just turn up the radio. :)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How tight should vacume lines hold onto connectors? [200][1993]
posted by  someone claiming to be BrickOCheese  on Thu Feb 20 13:01 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.