Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2003

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

front caliper pistons stuck on 240; any easy fix?

posted by  someone claiming to be 2OldVolvos on  Thu May 8 07:28 CST 2003 [RELATED]

I am in the process of putting new brake pads on the front of my 89 240 and it looks like the inside pistons are sticking in the Girling calipers.

I cant get them push in far enough to fit the new pad. However, the pistons do seem to push out OK because when I put a thin wooden spacer where the pad goes and pressed on the breaks, the 2 pistons tightened up on the spacer.

I was hoping that they would free up with the outward motion but I had no luck though trying to pry the pistons back into the caliper.

I have some silicon lube but I dont think I will be able to get it to where it needs to be without dissasembly.

Any ideas on how I can free them up without taking the calipers off and doing a rebuild or replacement?

I could use some advice.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New front caliper pistons stuck on 240; any easy fix?
posted by  someone claiming to be 2OldVolvos  on Thu May 8 07:28 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.