Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

control arm bushing, right side 200 1988

posted by  rockwellmusic on  Sun May 25 11:36 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I replaced my driver's side control arm bushings, and when I looked over to the passenger's side, I noticed that the exhaust pipe was right next to it, getting in the way of where you would put the wrench to tighten the rear (I think) bushing under load. It was a tight squeeze for the one that I did to get the wrench in there and move the bolt around. But I can't see how I'm going to fit the wrench in on the other side because of that exhaust pipe. Has anybody come across that same issue, and if so what is the fix?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New control arm bushing, right side [200][1988]
posted by  rockwellmusic  on Sun May 25 11:36 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.