Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2015 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

control arm bushing, right side 200 1988

posted by  someone claiming to be dschwied on  Wed Jun 4 20:48 CST 2003 [RELATED]


I cut a little slot (about 3/8" wide and 1 1/2" long) in the bottom of the
"pocket" that holds the rear of the control arm. This allowed me to fit the loosely tightened nut and stud into the pocket, bolt the three bolts tightly to the frame, and then reach up into the pocket to tighten the nut.

Worked fine. Just eyeball it to see where the slot needs to go. It comes off of the hole that's already in the pocket.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New control arm bushing, right side [200][1988]
posted by  rockwellmusic  on Sun May 25 11:36 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.