Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Need to bleed master cylinder...How to? 200 1975

posted by  Bruce S. on  Sun Jul 6 06:57 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 4 19:05 CST 2014
[RELATED]

Hello all,

I'm giving the brake system a good going over, I changed all the rubber lines and had the reservoir off to clean it, so the master cylinder has been drained. I picked up some brake lines (about 18 inches worth) from the pic-n-pull, but I need a refresher on the procedure.

Do the lines need to just dump fluid back into the reservoir or do they need to be submerged in the fluid? And can I short stroke it, I don't want to damage the seals by taking it to far.

Thanks,
--
Bruce S. near D.C.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Need to bleed master cylinder...How to? [200][1975]
posted by  Bruce S. subscriber  on Sun Jul 6 06:57 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.