Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Removing tilt knob 200

posted by  veesh on  Fri Jan 9 02:58 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Folks,

I'm replacing my 90 245 DL's driver's seat with a donor driver's seat from a '93. I'm going to use the frame and foam from the 93 on my car. I took off the vinyl but had a somewhat hard time taking off the tilt knob. I think I butchered it as a matter of fact. I will have to replace the plastic knob from another seat.

How do you take one of these off? There is a plastic cap that covers the inner workings of the knob. Inside, there is a thin metal disc that fits over a spindle. How do you remove the disc without damaging it? The forum for 7xx said to rotate CCW, but that didn't seem to work.

Any suggestions? Much appreciated,

Steve






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Removing tilt knob [200]
posted by  veesh  on Fri Jan 9 02:58 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.