Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How do I cut metal in my A/T Overdrive solenoid to turn it 'always on'? 200 1983

posted by  someone claiming to be kevin-at-vmware-dot-com on  Thu Jan 15 08:56 CST 2004 [RELATED]


In response to an earlier question of mine, Don Foster suggested that it might be possible to mechanically alter my 1983 240 Auto Trans overdrive solenoid such that I would have O/D "Always on" (and thus forget about the whole relay / wiring degradation issue altogether).

See earlier post: http://brickboard.com/RWD/index.htm?id=736583

Anyone out there actually done this and can provide some pointers on tools used, time taken to do this, etc? Am I better off just buying a new solenoid ($200) and installing it / getting someone to install it?

Thanks Don!


- KE





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How do I cut metal in my A/T Overdrive solenoid to turn it 'always on'? [200][1983]
posted by  someone claiming to be kevin-at-vmware-dot-com  on Thu Jan 15 08:56 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.