Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

air compressor with air tool question 200 1989

posted by  greg_mustang on  Mon Apr 5 06:15 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat May 10 07:26 CST 2014
[RELATED]

Sorry for the non-volvo spefic quesiton...

I have a CH (campbell housefield) compressor which someone gave me years ago.
Unfortunately it is tankless. It is electric 110V, oilless, and has a top mounted dial that ranges up to 100 PSI. It's got the usual hose fitting...

Can I use this to run an air wrench with socket for some basic auto mech work?
I am asking because even though it has 100 PSI I understand the air volume is very minimal. For example, would it work to losten say the top strut nuts at the front struts? How about undoing wheel lugnuts? Yes, I tighten with a torque wrench normally.

Let me know, if so I will go buy an air wrench and impact sockets.

Thanks,
Greg Mustang





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New air compressor with air tool question [200][1989]
posted by  greg_mustang  on Mon Apr 5 06:15 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.