Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

front wheel bearing seal 200 1987

posted by  lowsway240 on  Sun Jun 6 11:51 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Feb 10 16:43 CST 2010
[RELATED]

Howdy,
I am repacking the front wheel bearings, having the rotors turned and installing new brake pads. Upon puchasing the new inner seal I was confused as to how it was installed. This is the first time I have seen a seal sold without the metal ring attached to it ( the one you press on to install the seal in the hub.) The seal has a flap on one side and the other side is a bit conical. It looks just like the seal I pulled off but the install is not so easy..... The seal also has to be stretched over the spindle because its a bit smaller in diameter. sorry for the long babble. Any help would be greatly appreciated
T






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New front wheel bearing seal [200][1987]
posted by  lowsway240  on Sun Jun 6 11:51 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.