Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2011 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

engine misfires under high load 900 1995

posted by  Hauge on  Mon Aug 2 07:45 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I have a 945 with a B230FK, which is a low pressure turbo version.
Most of the time it runs fine. It has a fine idle and a fair fuel consumption.
The only problem is that when I give full throttle at low revs in first gear(manual transmission), it seems like one or two cylinders are cutting out. The problem is worse when I am towing my caravan. When the engines exceeds 3000 rev/min it starts to pull with full power, and I can shift for 2 gear and now it will keep pulling without problems even though the revs are lower. So the problem apparently only occurs in first gear.
I have changed ignition wires, plugs, the ignition power module and the knocking sensor, without any results. Does anyone have an idea of what to look for?

Hauge





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New engine misfires under high load [900][1995]
posted by  Hauge  on Mon Aug 2 07:45 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.