Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2006 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Tranny dipstick tube install 700

posted by  skim35 on  Mon Aug 23 06:59 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Trying to flush transmission. Pan dropped & reinstalled. But cannot reinstall the transmission dipstick tube (24mm hex nut from side of tranny pan) It appears to be thread alignment issue.

Need to wiggle the dipstick pipe to get it in position, but it is bolted down with the starter motor (18 mm, hex ). Not enough space for a impact wrench (should I invest $ to get smaller impact?) and cannot remove manually (I used 12 pt 18mm socket, should give you about 30' turning space, but dipstick tube is in the way.) Basically I am stuck.

Any idea how to remove this bottom starter motor bolt?

thanks in advance





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tranny dipstick tube install [700]
posted by  skim35  on Mon Aug 23 06:59 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.