Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Error in Bentley's? 200

posted by  jaydee on  Mon Nov 15 12:24 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 23:45 CST 2014
[RELATED]

I suppose this may have been discussed before, but there seems to be an error in the Bentley manual. Specifically, the example that is used for adjusting valve clearances (sec. 214-3) seems to be in error. It would seem that if I wish to decrease valve lash or gap I would install a thicker shim. However in the example cited by Bentley they in fact use a thinner shim. Anyone care to comment on my foolish misinterpretation, my rehashing an old subject, or gall in suggesting the book might be in error? :o)
Seriously, am I reading the example correctly?
JD






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Error in Bentley's? [200]
posted by  jaydee subscriber  on Mon Nov 15 12:24 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.