Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Cold start valve wiring 700 1990

posted by  John745 on  Fri Dec 3 17:27 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hello, I have recently have had a reoccuring problem with my check engine light coming on. Through this site I have learned a great amount about my car. The OBD code will flash 3-2-1 cold start valve. I finally broke down after many attempts at trying to figure this out and went ahead to replace the valve. When I unclipped the wiring from the injector a green-red wire came out of the harness and was not attached to anything. A blue-green wire runs from the injector to the starter coil, and is energized when the starter is engaged. The stray wire is live 10V. when the ingition is on. Should I hook this wire to the injector? If so, how? Thanks for any replies. John745.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Cold start valve wiring [700][1990]
posted by  John745  on Fri Dec 3 17:27 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.