Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2002 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

obdc diagnostic 2 codes 700 1988

posted by  someone claiming to be first 740 on  Fri Feb 4 12:31 CST 2005 [RELATED]

I could use some clarification of the FAQ/700-900/EngineOBDCodes.htm.
I had no stored fault codes. When testing sensors in mode 2, socket6 the TPS codes operate properly. For RPM when I crank the starter the LED stops flashing but displays no codes.
Diagnostic says RPM sensor faulty if no code is displayed and LED continues to flash.? I only have half the symptom?
When testing sensors in mode 2 socket 2 the TPS and RPM sensor signal from ignition codes are OK. Is this a different side of the RPM sensor?
My engine problem is intermittent failure to start, cold or warm. I have verified that this is due to no spark. I have voltage on coil primary. This brings up another point, a pink wire was installed from the starter solenoid to the coil, not OEM but professional with connectors and careful routing. Is this an attempt by PO to repair starting problem? I have disconnected it and intermittent starting persists.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New obdc diagnostic 2 codes [700][1988]
posted by  someone claiming to be first 740  on Fri Feb 4 12:31 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.